disk brakes and speedo drive

[delbertinie]

my speedo is driven off the front wheel so if I change spindles to disk brakes then what?

 

[Peter]

Stub axles and bearings and therefore the grease caps with the square hole in remain the same.

 

[letterman7]

Yep, no change. *thumbs up*

 

[delbertinie]

thanks i found some original disk brake spindles unfortunately thats all they are just the spindles got to find the rest of the stuff.

are the hubs part of the rotors or are the hubs and bearings seperate

thanks

 

[kruzer52]

the hubs and bearings mount onto the spindles.

 

[Peter]

The rotors and hubs are in one piece with taper bearings, the whole lot slips onto the stub axle and is held on by a simple tab washer and a special nut with an Allen bolt in it to lock it on.
You then pop a grease cap over the lot and fix the speedo cable through the stub axle and retain it in the cap with a small clip or pin.

 

[delbertinie]

yep just lie the drums