Brett Proctor
Well-known member
I did a write up for a tubing beader that works for my heater lines but that didn't work for the larger coolant lines used for the engine, so I needed to make something else that would work for that.
Started off getting this
But the tooling die was to large to fit inside of the 1 3/4" tubing that I was using .
So I welded together a few washers and rounded the edges off to make this
Started off getting this
But the tooling die was to large to fit inside of the 1 3/4" tubing that I was using .
So I welded together a few washers and rounded the edges off to make this